CITY OF PUYALLUP PERMITTING PORTAL

No

No

Building Division

* Final approval by the Building Official is required prior to use or occupancy. * Work shall not proceed until the inspector has approved the stages of construction. * Surface storm water shall be diverted from the building site and shall not drain onto adjacent properties. * I hereby acknowledge that I have read this Permit/Application, that the information given is correct; that I am the owner or the duly authorized agent of the owner; that plans submitted herewith are in compliance with all applicable city, county and state laws and that all construction will proceed in accordance with said laws. This permit shall expire if work is not commenced with 180 days or if the work is suspended for a period of 180 days. Permits expire two years from issuance. * By leaving the contractor information section blank, I hereby certify further that contractors (general or subcontractors) will not be hired to perform any work in association with this permit. I also certify that if I do choose to hire a contractor (general or subcontractor) I will only hire those contractors that are licensed by the State of Washington. * TO SCHEDULE INSPECTIONS, CHECK PERMIT STATUS OR TO MAKE PAYMENTS ON THE CITY WEB SITE VISIT https://secure.cityofpuyallup.org/ Plan review notes: 1. Special inspection: provide special inspection report to the city inspectors. The engineer of may inspect subject to owner's approval and as provided in section 1704.2 Special inspections and tests. 2015 IBC (excerpts) 1704.2 Special inspections and tests. Where application is made to the building official for construction as specified in Section 105, the owner or the owner's authorized agent, other than the contractor, shall employ one or more approved agencies to provide special inspections and tests during construction on the types of work specified in Section 1705 and identify the approved agencies to the building official. These special inspections and tests are in addition to the inspections by the building official that are identified in Section 110. TABLE 1705.3- REQUIRED SPECIAL INSPECTIONS AND TESTS OF CONCRETE CONSTRUCTION 4.Inspect anchors post-installed in hardened concrete members. a. Adhesive anchors installed in horizontally or upwardly inclined orientations to resist sustained tension loads. b. Mechanical anchors and adhesive anchors not defined in 4.a 2. Comply with engineer design and installation recommendations.

Building Division

PERMIT CONDITIONS: ALL EXTERIOR MECHANICAL EQUPMENT SHALL BE SCREENED FROM VIEW OF SURROUNDING PUBLIC STREETS AND RESIDENTIAL PROPERTIES. ***SUBJECT TO FINAL INSPECTION*** Call the inspection line at 1-877-232-6456 to schedule inspections. Use the Permit ID located at the top right of the permit when prompted for Permit ID. The City attempts to honor the AM/PM requested inspection, but cannot guarantee that service. Please call Monty - East of Meridian at 253-770-3326 or Shannon - West of Meridian at 253-840-6684 before 8:30 AM on the day of inspection to verify time. Plan review notes: 1. Temperature controls must meet code requirement. simultaneous heating and cooling is not allowed by code. 2. Special inspection: provide special inspection report to the city inspectors. The engineer of may inspect subject to owner's approval and as provided in section 1704.2 Special inspections and tests. 2015 IBC (excerpts) 1704.2 Special inspections and tests. Where application is made to the building official for construction as specified in Section 105, the owner or the owner's authorized agent, other than the contractor, shall employ one or more approved agencies to provide special inspections and tests during construction on the types of work specified in Section 1705 and identify the approved agencies to the building official. These special inspections and tests are in addition to the inspections by the building official that are identified in Section 110. TABLE 1705.3- REQUIRED SPECIAL INSPECTIONS AND TESTS OF CONCRETE CONSTRUCTION 4.Inspect anchors post-installed in hardened concrete members. a. Adhesive anchors installed in horizontally or upwardly inclined orientations to resist sustained tension loads. b. Mechanical anchors and adhesive anchors not defined in 4.a 3. Comply with engineer design and installation recommendations.