CITY OF PUYALLUP PERMITTING PORTAL

APPLICANT/CONTRACTOR REQUIREMENTS: 1. PERMIT AND APPROVED TRAFFIC CONTROL PLAN ARE REQUIRED TO BE AVAILABLE AT JOB SITE. NOT HAVING A PERMIT ONSITE SHALL BE SUBJECT TO TRIPLE PERMIT FEE. 2. THE CITY SHALL BE NOTIFIED 24-48 HOURS PRIOR TO JOB START 3. THE CITY SHALL BE NOTIFIED WHEN ALL WORK AND RESTORATION IS COMPETE AND READY FOR FINAL INSPECTION. PRIOR TO RESTORATION, COORDINATE WITH AN INSPECTOR. *** SITE SPECIFIC CONDITIONS *** The City of Puyallup does not authorize or permit work in other jurisdictions. Please apply for the necessary permits with the other governing jurisdictions. Poles 1, 2, 5, 6, 7, and 8 on this site plan are not within Puyallup City limits. All proposed franchise utilities shall be located within a recorded utility easement or in the public right-of-way as determined by the City of Puyallup. The City of Puyallup does not authorize or permit utility work on private property. All vehicles, equipment, and personnel are prohibited at all times from occupying any portion of the railroad crossing. Railroad crossing signs and striping shall be visible at all times. Vehicle and pedestrian traffic shall not be queued on the railroad crossing. All aerial crossings at an intersection shall be a maximum of 3 minutes. The applicant shall contact Tamara Ferrin, Puyallup Police Department Support Specialist, at 253-841-5436 or tame@puyallupwa.gov to coordinate traffic support with a uniformed police officer at least 24 hours of job start. GENERAL CONDITIONS: 1. Follow approved Traffic Control Plan (TCP) 2. Follow allowed work hours as seen on each page of the issued traffic control plans. 3. If a lane will be closed, call Comm Center on day of closure prior to work start at 253-287-4456. 4. Spotter must be available to assist with pedestrians if needed. 5. To schedule inspection, go to: Secure.cityofpuyallup.org and select appropriate code. 6. Please utilize traffic control information below for TCP: A. Distance between cones equals speed limit in unit feet. B. Taper length equals width of offset times speed limit squared divided by 60. L = WS² /60 - W= lane width S = speed limit C. Sign spacing shall be 100 feet when speed limit is 30 MPH or less D. Sign spacing shall be 350 feet when speed limit is greater than 30 MPH E. Distance between signs is mandatory unless field conditions determine otherwise. 7. Do not open cut without prior approval. 8. Do not park vehicles on city sidewalk. Curb, gutter or sidewalk damaged shall be replaced. Inspection time performed during a regular 8-hour day Monday through Friday 7:00 am - 5:00 pm is included in the permit fee. Inspection time performed outside of those hours are charged to the permit holder at a rate of $130 per hour with a three-hour minimum. INDEMNIFICATION / HOLD HARMLESS: The Permittee shall defend, indemnify and hold the Public Entity, its officers, officials, employees and volunteers harmless from any and all claims, injuries, damages, losses or suits including attorney fees, arising out of or in connection with activities or operations performed by the Permittee or on the Permittee's behalf out of issuance of this Permit, except for injuries and damages caused by the sole negligence of the Public Entity. However, should a court of competent jurisdiction determine that RCW 4.24.115 applies to this Permit, then the Permittee agrees to defend, indemnify and hold the Public Entity, its officers, officials, employees and volunteers harmless to the maximum extent permitted thereunder. It is further specifically and expressly understood that the indemnification provided herein constitutes the Permittee's waiver of immunity under Industrial Insurance, Title 51 RCW, solely for the purposes of this indemnification. This waiver has been mutually negotiated by the parties. The provisions of this section shall survive the expiration or termination of this Agreement.