CITY OF PUYALLUP PERMITTING PORTAL

Building Division

* Final approval by the Building Official is required prior to use or occupancy.* Work shall not proceed until the inspector has approved the stages of construction.* Surface storm water shall be diverted from the building site and shall not drain onto adjacent properties.* I hereby acknowledge that I have read this Permit/Application, that the information given is correct; that I am the owner or the duly authorized agent of the owner; that plans submitted herewith are in compliance with all applicable city, county and state laws and that all construction will proceed in accordance with said laws. This permit shall expire if work is not commenced with 180 days or if the work is suspended for a period of 180 days. Permits expire two years from issuance. * By leaving the contractor information section blank, I hereby certify further that contractors (general or subcontractors) will not be hired to perform any work in association with this permit. I also certify that if I do choose to hire a contractor (general or subcontractor) I will only hire those contractors that are licensed by the State of Washington. If you are a property owner, contractor or permittee and you are paying for someone to perform the work, they must have a valid contractor registration and the person(s) installing plumbing inside a structure must meet the plumbing certification requirements. If you have any questions regarding these regulations, you may contact the Washington State Department of Labor and Industries or you can find more information on-line at: http://www.lni.wa.gov/TradesLicensing/Contractors/HireCon/default.asp

Planning Division

Monument signs in RM zones shall conform with the maximum setback and height regulations of PMC 20.60.065 (5), "Specific sign requirements by sign type": (5) Monument Signs. Unless otherwise stated in this chapter, monument signs in all zones are subject to the following provisions: (a) The height of a monument sign shall be measured from the finished grade immediately abutting the base of the sign; in no event shall a monument sign be installed on an earthen berm, retaining wall or otherwise artificially created/graded surface as to elevate it above the surrounding landscape in an effort to exceed the maximum height for monument signs set forth herein. (b) Height and Setbacks for Monument Signs. Monument signs shall be allowed within the setback areas of a property if they meet the following standards: (i) Monument signs shall be set back at least five feet from the public right-of-way, regardless of the setback requirement of the zone. (ii) Monument signs shall be no greater in height than one foot above the adjoining finished grade for each foot of setback to a maximum of 10 feet in height. (iii) Placement of monument signs shall not interfere with any vehicular sight-distance requirements, as determined by the city engineer, nor shall it interfere with any pedestrian access. (c) Monument signs shall incorporate the same building materials in their design as the building to which they apply or an approved alternative high-quality material (e.g., stone veneer). (d) Monument signs which do not encroach into required front or side yard setbacks shall conform with the requirements for freestanding signs for the applicable zone. (e) Landscaping. Landscaping around the base of a monument sign shall be required in those instances where a sign is proposed for placement within or adjacent to an existing landscaped area on a site. Landscaping shall include a mix of groundcovers and shrubs.

Development & Permitting Services

Contractor needs to have a valid City of Puyallup business license endorsement with Washington State Department of Revenue.